>Dragon box Pinfinding Problem Solved

>

  • Open your Gpg Dragon box
  • Connect your box to A-B connector
  • While your box is connected, connect you multitester rod shown to this image…
  • after you hear a beep….disconect mutitester….
  • then disconnect A-B connector…
  • then wait a few minutes…..
  • then reconnect box…
  • then upgrade your box firmware to this: Firmware 1.58
  • then your box is back to work again….
This entry was posted in Gpg Dragon and tagged . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *